diff options
Diffstat (limited to 'useful_files')
| -rw-r--r-- | useful_files/TS4231_NOTES.md | 18 |
1 files changed, 18 insertions, 0 deletions
diff --git a/useful_files/TS4231_NOTES.md b/useful_files/TS4231_NOTES.md new file mode 100644 index 0000000..469e8bd --- /dev/null +++ b/useful_files/TS4231_NOTES.md @@ -0,0 +1,18 @@ +Based on u_cap's initial findings... + +Here's what I see +The Github default of 0x392B lets me see reasonable (if noisy) E and D signals with an HTC base in default settings +The 0x3FFF that I thought I had read back from a power-cycled TS4231 shows the same when set explicitly: E and D present. I probably did not set the bus up properly for reading the config(edited) +Using 0x2BA8 I get D==0 and E==1 , no changes +configDevice has an initial section that tries to get in S3_STATE before setting a config +if I take that out in its entirety, we are in S0_STATE, and reading back the config will get 0x3FFF - I suspect that is a bogus result(edited) +if Ileave the bus setup section in and read (but not write) the config after S3_STATE has been reached, I get a default of 0x0 read(edited) +this default state will also show me E==1 and D==0, no changes(edited) +same result if I set 0 explicitly - apparently a valid config, but not working with HTC bases(edited) +summary: If I set the GitHub default config, I get E+D and everything works fine. If I set 0x3FFF, same result +If I set 0x2BA8, I D and E show no changes ever with HTC base. same if I set 0, or if I just power cycle and do not set a config, in which case the config reads as 0 as long as I read in S3_STATE +I'll try different frequencies w/ 0x2BA8 and 0 next. the behavior of the default/zero config makes no sense as a legacy Gen1 support, so maybe its a Gen2 default? +I never see E-only +on a related note, I need to find a better way to power-cycle the TS4231 +from a Teensy +right now I power-cycle both. |