aboutsummaryrefslogtreecommitdiff
path: root/useful_files/TS4231_NOTES.md
blob: 469e8bdc2e11ef0e06b35f3037c558813eba8632 (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Based on u_cap's initial findings...

Here's what I see
The Github default of 0x392B lets me see reasonable (if noisy) E and D signals with an HTC base in default settings
The 0x3FFF that I thought I had read back from a power-cycled TS4231 shows the same when set explicitly: E and D present. I probably did not set the bus up properly for reading the config(edited)
Using 0x2BA8 I get D==0 and E==1 , no changes
configDevice has an initial section that tries to get in S3_STATE before setting a config
if I take that out in its entirety, we are in S0_STATE, and reading back the config will get 0x3FFF - I suspect that is a bogus result(edited)
if Ileave the bus setup section in and read (but not write) the config after S3_STATE has been reached, I get a default of 0x0 read(edited)
this default state will also show me E==1 and D==0, no changes(edited)
same result if I set 0 explicitly - apparently a valid config, but not working with HTC bases(edited)
summary: If I set the GitHub default config, I get E+D and everything works fine. If I set 0x3FFF, same result
If I set 0x2BA8, I D and E show no changes ever with HTC base. same if I set 0, or if I just power cycle and do not set a config, in which case the config reads as 0 as long as I read in S3_STATE
I'll try different frequencies w/ 0x2BA8  and 0 next. the behavior of the default/zero config makes no sense as a legacy Gen1 support, so maybe its a Gen2 default?
I never see E-only
on a related note, I need to find a better way to power-cycle the TS4231
from a Teensy
right now I power-cycle both.